10-27
Troubleshooting > Troubleshooting
T
U
W
Message Checkpoints Corrective Actions
Reference
Page
The cover is open. Is there any cover which is open? Close the cover indicated on the
screen.
—
The device cannot be
connected because
allowed connections
would be exceeded.
— Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
—
The manufacturer
assumes no
responsibility for
damage caused by a
non-genuine toner.
Is the installed toner container our
own brand?
We will not be liable for any damage
caused by the use of third party
supplies in this machine. If you want
to continue, select [Next].
—
The phone receiver is off
the hook.
— Put down the receiver. —
The SD Card is not
formatted.
Is the SD Card formatted by this
machine?
Select a format option from the
System Menu, under [Common
Settings].
page 8-19
The slit glass requires
cleaning.
— Clean the slit glass. page 10-3
The toner container is
not properly installed.
Are the toner container and
developer unit installed correctly?
Correctly install the toner container
and developer unit.
page 10-4
This ID card is already
registered to another
user.
— Your ID card has already been
registered. Change it to another ID
card.
—
This memory is not
formatted.
This will be formatted.
Are you sure?
Is the removable memory formatted
by this machine?
Perform [Format] on this machine. —
This user account is
locked out.
— Contact administrator.
Job is canceled. Select [End].
—
Toner is empty. — Replace the toner container. page 10-7
Toner is low. (Replace
when empty.)
— It is almost time to replace the toner
container. Obtain a new toner
container.
—
Message Checkpoints Corrective Actions
Reference
Page
Unknown Toner
Installed. PC
Does the installed toner container's
regional specification match the
machine's?
Install the specified container. ―
Message Checkpoints Corrective Actions
Reference
Page
Warning low memory. — Cannot start the job. Try again later. —