2-37
Installing and Setting up the Machine > Command Center RX
Changing Security Settings
This section explains how to change the security settings.
1
Display the screen.
1 Launch your Web browser.
2 In the address or location bar, enter the machine's IP address or the host name.
Press [Device Information] in the home screen and then [Identification/Network] to check the
machine's IP address or the host name.
3 Log in with administrator privileges.
The factory default setting for the default user with administrator privileges is shown below.
* Upper case and lower case letters are distinguished (case sensitive).
4 Click [Security Settings].
Device Information Identification/Network
To Next Page
Loading...
