Printer Driver 7-1
7 Finishing
In the Finishing tab, you can specify document finishing features such as
separating sets of printed jobs, aligning matching sides of two different page
sizes in a document, creating a gutter, and stapling. Selections vary by printing
system model.
To return to the original settings, click Reset. This also restores the Destination
selection in the Basic tab. The Reset button is available when accessing the
printer driver from the application's Print dialog box.
Separation
With this feature, you can stack print jobs so that one print job can be
distinguished from another.
Note: Separation features cannot be used with Binding edge or with Staple.
Selections vary by printing system model.
Offset Jobs
With this feature, you can physically shift each print job in the output tray.
To ensure consistent offset stacking, all users printing to the same printing
system should select Offset jobs as the default setting.
The Offset jobs feature requires a finishing device to be selected under Device
options in the Device Settings tab. It does not work with the Staple or the
Binding edge features. Selections vary by printing system model.
To Next Page
Loading...
