4-12
Printing from PC > Printing Data Saved on the Printer
Printing Document from Stored Job Box
In Stored Job, the print data sent from the application is saved to the machine. You can set up an access code as
necessary. If you set up an access code, enter the access code when printing. Print data will be stored in the Stored Job
Box after printing. This will allow printing of the same print data repeatedly.
The following operations are possible:
Printing the Documents (page 4-12)
Deleting the Documents (page 4-13)
Printing the Documents
Print the documents stored in a Stored Job box. The procedure is as follows.
1
Display the screen.
1
[
Menu
] key > [▲] [
] key > [
Job Box
] > [►] key > [▲] [
] key > [
Private/Stored
] >
[
OK
] key
2
Select the creator of the document, and select the [
OK
] key.
2
Print the document.
1
Select the document to print.
[All Files] > [▲] [▼] key > [OK] key
To apply this process to all documents in Private/Stored Job, select [All Files].
2
Specify the number of copies to print as desired, and select the [
OK
] key.
Printing starts.
• If the document is protected by an access code, the password entry screen will be
displayed. Enter the password using the arrow keys, and then select [
OK
] key.
• If you selected [
All Files
] and the access code does not match any of the documents,
and in addition there are no documents without access codes, "ID error" is displayed.
• If you selected [
All Files
], select [▲] key after "Copies ---" is displayed to set the
number of copies.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
