2FM
1-6-13
(4) Removing the bias board
1. Remove the cassette and process unit (See page 1-6-2).
2. Remove the left cover (See page 1-6-4).
3. Remove the power supply board and high voltage board (See the previous page).
4. Turn the machine with the bottom side up.
5. Remove the one stop ring and then remove the roller guide.
6. Remove two axis pins and then remove the conveying guide.
Figure 1-6-14 Removing the conveying guide
Stop ring
Roller guide
Conveying guide
Axis pins
To Next Page
Loading...
