Troubleshooting
10-6 OPERATION GUIDE
Paper jammed. – If a paper jam occurs, the machine
will stop and the location of the jam
will be indicated on the Message
Display. Leave the machine on and
follow the instruction to remove the
jammed paper.
10-9
USB memory error.
Job is canceled.
– This job is canceled. Press the OK
key.
—
Place original
and press Start key.
– Remove originals from the document
processor, put them back in their
original order, and place them again.
Press the Start key to resume
printing.
Press the Stop key to cancel the job.
2-31
Remove original from
document processor.
Are there any originals left in
the document processor?
Remove originals from the document
processor.
—
Maximum Number of
scanned pages.
Job is canceled.
– Scanning cannot be performed due
to insufficient memory of scanner.
The job is canceled. Press the OK
key.
—
Is the acceptable scanning
count exceeded?
Press the OK key to print, send or
store the scanned pages. Press the
Stop key to cancel printing, sending
or storing.
—
Send error.
####
– 5101, 5102, 5103, 5104, 7102, 720f:
Turn the main power switch off and
back on. If this error occurs several
times, make a note of the displayed
error code and contact your service
representative.(Refer to the
corrective action for the error
message “An error has occurred.”)
9181: The scanned original exceeds
the acceptable number of pages of
999. Send the excess pages
separately.
—
Error occurred.
Turn the main power
switch off and on.
– System error has occurred. Turn the
main power switch off and on.
—
The phone receiver is
off the hook.
Hang Up.
– Put down the receiver. —
File is not found.
Job is canceled.
– The specified file is not found. The
job is canceled. Press the OK key.
—
Error Message Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
