Using the Operation Panel
2-74 ADVANCED OPERATION GUIDE
5
To change overriding mode, press [OK]. A
blinking question mark (?) appears.
6
Press ? or @ to change Off to On.
7
Press [OK]. The overriding mode is set.
8
To exit the menu selection, press [Menu].
Creating Custom Paper Type
The following describes the procedure used to set a user-defined paper
type for the printer. Eight custom user settings may be registered. After
having been set, any of these may be called up when setting the paper
type for a paper source.
The paper weight and duplex path can be set (refer to Setting the Paper
Weight on page 2-75, and Setting the Duplex Path on page 2-75) after
selecting the paper type to be customized as follows. For how to reset the
customized settings, refer to Resetting the Custom Paper Type on page 2-
76.
1
Press [Menu].
2
Press ? or @ repeatedly until Paper
Handling > appears.
3
Press B.
4
Press ? or @ repeatedly until >Type
Adjust > appears.
5
Press [OK]. A blinking question mark (?)
appears.
6
Press ? or @ to display the desired paper type. The display changes as
shown below.
Custom 1 (to 8)
Plain
Transparency
Preprinted
Labels
Bond
Recycled
Vellum
>Override A4/LT
? Off
Paper Handling >
>Type Adjust >
Custom 1
>Type Adjust
? Custom 1
To Next Page
Loading...
