Kyocera FS-2000D - Automatic Form Feed Timeout Setting; Setting the Sleep Timer

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-79
7
Press [OK].
8
Press [Menu]. The display returns to Ready .
Automatic Form Feed Timeout Setting
If the printer receives no data for a certain period, it will time out and
release the current interface. It prints whatever data it has in its buffer and
feeds out the page. The default form feed timeout time is 30 seconds.
1
Press [Menu].
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
4
Press ? or @ repeatedly until >Form Feed
Time Out appears.
5
To change the timeout time, press [OK]. A
blinking cursor (_) appears.
6
Press ? or @ to increase or decrease the value at the blinking cursor and
set the desired time. The timeout time can be between 0 and 495 seconds,
in 5-second increments. Use B and A to move the cursor right and left.
7
When the desired timeout time is displayed, press [OK].
8
To exit the menu selection, press [Menu].
Setting the Sleep Timer
The printer has a sleep timer that is used to conserve power when the
printer is not printing, processing, or receiving data.
1
Press [Menu].
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
Others >
>Form Feed
Time Out 030sec.
>Form Feed
Time Out 030
sec.
Others >