Computer Interface
ADVANCED OPERATION GUIDE 4-9
PRESCRIBE FRPO D0 Command
The PRESCRIBE FRPO D0 command is provided to allow manipulating
XON/XOFF when an error has occurred on the serial interface. The
following table summarizes the error status corresponding to different D0
values.
Timing of XON transfer to
host while Ready or
Waiting
Serial interface error
error not handled error handled
XON sent every 3-5
seconds
D0=0 (default) D0=1
XON not sent D0=10 D0=11
To Next Page
Loading...
