Using the Operation Panel
2-86 ADVANCED OPERATION GUIDE
immediately without any time interval. You can use B and A to move the
cursor right and left.
8
Display the desired time and press [OK].
9
Press [Menu]. The display returns to Ready.
Duplex Printing Error Detection Setting
If the error detection setting for duplex printing has been turned On, and
you attempt to print onto a paper size and paper type that cannot be used
for duplex printing, the Duplex disabled Press GO error message will
be displayed and printing will stop. To print onto one-side of the paper only
when this message is displayed, press [GO]. The default setting is Off.
1
Press [Menu].
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
4
Press ? or @ repeatedly until
>Finishing Error > appears.
5
Press B and display >>Duplex.
6
Press [OK]. A blinking question mark (?)
appears.
7
Press ? or @ to change Off to On.
8
Press [OK].
9
To exit the menu selection, press [Menu].
Others >
>Finishing >
Error
>>Duplex
Off
>>Duplex
? Off
>>Duplex
? On
To Next Page
Loading...
