Using the Operation Panel
ADVANCED OPERATION GUIDE 2-85
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
4
Press ? or @ repeatedly until >Auto
Error Clear > appears.
5
Press [OK]. A blinking question mark (?)
appears.
6
Select On or Off using ? or @.
7
Press [OK].
8
To exit the menu selection, press [Menu]. The display returns to Ready.
Setting the Error Clear Time
1
Press [Menu].
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
4
Press ? or @ repeatedly until >Auto
Error Clear > appears.
5
Press B and display >>Error Clear
Timer. The default setting is 30 seconds.
6
Press [OK]. A blinking cursor (_) appears.
7
Press ? or @ to increase or decrease the value at the blinking cursor and
set the desired time. The time must be set between 000 and 495 seconds,
in 5-second increments. If set to 000, printing will be continued
Others >
>Auto Error >
Clear Off
>Auto Error
Clear ? Off
Others >
>Auto Error >
Clear On
>>Error Clear
Timer 030sec.
>>Error Clear
Timer 030
sec.
To Next Page
Loading...
