Kyocera FS-2000D - Indicators in Message Display

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-5
Indicators in Message Display
Interface Indicator (INTERFACE)
The interface indicator shows the interface that is currently in use:
Each interface has a timeout time of 30 seconds (factory default) during
which the other interface should wait to receive a print job. Even after a
print job has been completed on the interface, you should wait for this
period until the other interface begins printing the job.
Paper Size Indicator (SIZE)
This indicator shows:
• While the printer is in standby, the paper size of the current cassette.
The default paper cassette is determined by the operation panel keys.
For details, refer to Paper Handling on page 2-64.
• While the printer is printing, the paper size used to format the
document to print by the application software.
The abbreviations used to indicate the paper sizes and their dimensions
are as follows:
Ready
PAR A4 PLAIN
PAR Parallel interface is in use.
USB USB interface is in use.
SER Serial (RS-232C) interface is in use. (option)
NET Network interface is in use. (FS-2000D: appears only when
the optional network interface card IB-30 is installed.)
OPT Network interface is in use. (option)
--- No interface is in use.
A4 ISO A4 (210 × 297mm)
A5 ISO A5 (148 × 210mm)
A6 ISO A6 (105 × 148mm)
†
B5 JIS B5 (182 × 257mm)
B6 JIS B6 (128 × 182mm)
††
LT Letter (8 1/2 × 11 inches)
LG Legal (8
1/2 × 14 inches)