EasyManua.ls Logo

Kyocera FS-2000D - E-MPS

Kyocera FS-2000D
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using the Operation Panel
ADVANCED OPERATION GUIDE 2-19
e-MPS
e-MPS is an abbreviation for enhanced-Multiple Printing System which
implements the following functions that are available from the printer
driver:
Job Retention
Job Storage
In either job mode, when printing a document, the print data is transferred
from the computer to the printer then stored on the printer’s hard disk.
Since copies of the document are printed using the stored data, printing is
performed faster with less computer spooling time and less network traffic.
NOTE: To use the e-MPS system, an optional Microdrive must be
installed in the printer. For details, refer to Microdrive (Hard Disk)/
CompactFlash (Memory) Card on page 3-6.
The RAM disk may also be used in the Proof-and-Hold and Private Print
modes. Refer to Using the RAM Disk on page 2-61 for details on RAM
disk setup.
Job Retention
Job Retention has four modes as summarized below. These modes are
selected from the printer driver through the application software:
Quick Copy Proof-and-Hold Private Print Stored Job
Primary function To later print
additional copies
To proof the first
copy before printing
multiple copies
To hold the
document in printer
to prevent
unauthorized
access
To electronically
store documents
such as fax cover
pages
Start storing by Printer driver Printer driver Printer driver Printer driver
On terminating print
setting from
application software
Prints
simultaneously
Prints one copy
simultaneously
Does not print Does not print
Retrieved by Operation Panel Operation Panel Operation Panel Operation Panel
Default number of
copies printed at
retrieval
Same as storing
(can be changed)
One less
(can be changed)
Same as storing
(can be changed)
One
(can be changed)
Maximum number
of jobs stored
32, expandable to
50
32, expandable to
50
Depends on the
Microdrive capacity
Depends on the
Microdrive capacity
PIN security No No Yes Yes (if necessary)
Data after printing Stored Stored Deleted Stored
Data at power off Deleted Deleted Deleted Stored
†. Jobs in excess will cause the earlier ones to be deleted.

Table of Contents

Other manuals for Kyocera FS-2000D

Related product manuals