Kyocera FS-2000D - Making Default Settings

Using the Operation Panel
2-38 ADVANCED OPERATION GUIDE
Making Default Settings
Using the operation panel, you can set the default for the following items.
Default Emulation
You can change the emulation mode and character code set for the current
interface.
The printer can automatically change the emulation mode according to the
print job that is received from the computer. To do this, select KPDL
(AUTO) in the following procedure.
1
Press [Menu].
2
Press ? or @ repeatedly until Emulation > appears on the message
display. One of the emulation modes appears, indicating the emulation
currently in use.
PCL 6 (default)
KPDL
KPDL (AUTO)
Line Printer
IBM Proprinter
DIABLO 630
EPSON LQ-850
To change the default emulation, press
[OK]. A blinking question mark (?) appears.
3
Press ? or @ repeatedly until the desired emulation mode is displayed.
4
Press [OK].
5
Press [Menu]. The display returns to Ready.
Printing KPDL Errors
The printer can print error descriptions when printing error occurs during
KPDL emulation. The default is Off — the printer does not print KPDL
errors.
1
Press [Menu].
2
Press ? or @ repeatedly until Emulation > appears.
3
Press [OK]. A blinking question mark (?)
appears.
Emulation
?PCL 6
Emulation
?PCL 6