Kyocera FS-2000D - Changing Serial Interface Parameters

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-31
8
Press ? or @ to scroll through the following communication modes:
• Nibble (high)
• Auto
• Normal
• High speed
9
When the desired communication mode is displayed, press [OK].
10
Press [Menu] to exit the menu selection.
Changing Serial Interface Parameters
NOTE: This section applies to the printer having the optional serial
interface board kit (IB-11) installed.
You can confirm or change the serial interface parameters including baud
rate, data bits, stop bits, parity, and protocol. These parameters must
match those of the computer’s serial interface.
1
Press [Menu].
2
Press ? or @ repeatedly until Interface > appears.
3
If the interface is other than serial, press
[OK]. A blinking question mark (?) appears.
4
Press ? or @ repeatedly until Serial
appears.
5
Press [OK] again.
6
Press B. One of the following serial parameters is indicated (Baud rate
for example).
Interface
? Parallel
Interface
? Serial