Using the Operation Panel
2-32 ADVANCED OPERATION GUIDE
Pressing ? or @ toggles through the serial parameters as follows. To
change the serial parameter, press [OK]. Use ? or @ to change the value
or selection.
For example, to change baud rate from
9600 to 115200, display the baud rate
menu following the above procedure. When
the display shows baud rate, 9600 (bps),
press [OK]. A blinking question mark (?)
appears.
7
Press ? or @ to scroll through values. When 115200 is displayed, press
[OK]. Press [Menu] to exit the menu selection.
NOTE: Some computers may not be able to handle a baud rate of
115200 bps. If you set the baud rate to 115200 and encounter
communication problems, select a lower baud rate.
Range
>Baud Rate
9600
1200, 2400, 4800, 9600 (Default),
19200, 38400, 57600, 115200
>Data Bits
8
7 or 8 (Default)
>Stop Bits
1
1 (Default) or 2
>Parity
None
None (Default), Odd, Even, or Ignore
>Protocol
DTR(pos.)&XON
DTR(pos.)& Xon (Default),
DTR(positive), DTR(negative),
XON/XOFF, or ETX/ACK
>Baud Rate
? 9600
To Next Page
Loading...
