Kyocera FS-2000D - Page 109

Using the Operation Panel
ADVANCED OPERATION GUIDE 2-83
By default, resource protection is deactivated.
1
Press [Menu].
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
4
Press ? or @ repeatedly until >Resource
Prot. appears.
5
Press [OK]. A blinking question mark (?)
appears.
6
Press ? or @ to select Permanent or Perm / Temp (Permanent/
Temporary) for resource protection.
7
When the desired resource protection is displayed, press [OK].
8
To exit the menu selection, press [Menu].
Alarm (Buzzer) Setting
You can set an alarm sound in addition to the message displayed when the
paper supply is exhausted, or when paper jamming occurs. This setting is
useful, for example, when the printer is located some distance from the
user.
The audio alarm is set to On when leaving the factory. If the alarm is set to
Off, it will not sound.
1
Press [Menu].
2
Press ? or @ repeatedly until Others >
appears.
3
Press B.
4
Press ? or @ repeatedly until >Buzzer >
appears.
5
Press B.
Others >
>Resource Prot.
Permanent
>Resource Prot.
?
Permanent
Others >
>Buzzer >