Using the Operation Panel
2-26 ADVANCED OPERATION GUIDE
6
Press [OK] again. The printer prints a list of jobs currently posted in the
virtual mailboxes as shown in the following illustration.
Changing e-MPS Configuration
You can change the following parameters for e-MPS operation:
• Maximum number of Quick Copy/Proof-and-Hold jobs
• Maximum space assigned to temporary code jobs
• Maximum space assigned to permanent code jobs
• Maximum space assigned to virtual mailboxes
NOTE: The total amount of storage areas specified must not exceed the
total size of the Microdrive.
Changing the Maximum Number of Quick Copy/Proof-and-Hold Jobs
This changes maximum number of Quick Copy/Proof-and-Hold jobs from
0 to 50. The default is 32.
1
Press [Menu].
2
Press ? or @ repeatedly until e-MPS >
appears.
3
Press B.
4
Press ? or @ repeatedly until >e-MPS
Configuration > appears.
5
Press B.
e-MPS >
>e-MPS >
Configuration
To Next Page
Loading...
