Using the Operation Panel
2-28 ADVANCED OPERATION GUIDE
9
When the desired size is displayed, press [OK].
10
Press [Menu]. The display returns to Ready.
Maximum Space Assigned to Permanent Code Jobs
This changes the Microdrive space that holds permanent code jobs. You
can change the maximum space from 0 to 9999 (megabytes). The actual
maximum size depends on the size of free Microdrive space. The default
size is 1/6 of the total Microdrive space, rounded off in units of 50MB. For
example, if the total Microdrive space is 10GB, the default size is 1550MB.
1
Press [Menu].
2
Press ? or @ and select e-MPS >.
3
Press B.
4
Press ? or @ and select >e-MPS
Configuration >.
5
Press B.
6
Press ? or @ and select >>Perm. Code
JOB Size.
7
Press [OK], the message display shows a
blinking cursor (_).
8
Press ? or @ to increase or decrease, respectively, the value at the
blinking cursor. Use B and A to move the cursor right and left.
9
When the desired size is displayed, press [OK].
10
Press [Menu] and the display returns to Ready.
e-MPS >
>e-MPS >
Configuration
>>Perm. Code JOB
Size 1550MB
>>Perm. Code JOB
Size 1550
MB
To Next Page
Loading...
