Kyocera FS-9500DN Service Manual

Maintenance
Description
item No.
FS-9120DN/9520DN
1-4-20
U144 Setting toner loading operation
Description
Sets toner loading operation after completion of printing.
Purpose
To set whether or not toner is loaded on the drum after low density printing. Normally no change is necessary
from the initial setting.
Method
1. Enter the maintenance mode and press the or key to display "U144".
2. Press the ENTER key. "?" will be displayed.
>Set Toner Mode
[U144] ? Mode2
3. Press the or key to select the desired mode.
Display Description
MODE0 Toner not loaded
MODE1 Toner not loaded
MODE2 Toner loaded
Initial setting: MODE2
4. Press the ENTER key. The setting is set.
To keep the setting, press the CANCEL key.
U150 Checking sensors
Description
Displays the status of each sensor.
Purpose
To check if the sensors operate correctly.
Method
1. Enter the maintenance mode and press the or key to display "U150".
>Check Sensor >
[U150]
2. Press the key to display the submenu screen.
The status of each sensor will be displayed.
Display Switches
TonToner container sensor (TCS)
WatTon Overflow sensor (OFS)
F-down Paper full sensor (PFS)
3. Turn on or off the switch to check the status of the sensor. 0: Off 1: On
>>Ton:0 WstTon:0
[150.1] F-down:0

Kyocera FS-9500DN Specifications

General

Brand	Kyocera
Model	FS-9500DN
Category	All in One Printer
Language	English