FS-9120DN/9520DN
1-4-27
Maintenance
Description
item No.
U393 Initializing data for FRPO
Description
Initializes each preset value of FRPO.
Purpose
To reset each preset value of FRPO to the initial values.
Method
1. Enter the maintenance mode and press the or key to display "U393".
>Initialize >
[U393] Menu
2. Press the key to display the submenu screen.
3. Press the ENTER key. "?" will be displayed.
>>FRPO INIT
[393.1] ?
4. Press the ENTER key. Each setting will be initialized.
To keep the setting, press the CANCEL key.
U394 Adjusting the leading edge margin of image printing for each paper cassette
Description
Adjusts the leading edge margin of image printing for each paper cassette.
Purpose
To adjust the leading edge margin if it is displaced depending on the paper cassette. Before adjusting this item,
use U402 to adjust the leading edge margin for the upper cassette of the printer.
Method
1. Enter the maintenance mode and press the or key to display "U394".
>Set Paper Feed>
[U394] Top Reg.
2. Press the key to display the submenu screen.
3. Press the or key to select the item for which the preset value is to be changed.
Display Description Setting range Initial setting
Cassette 2 Leading edge margin for lower cassette of -128 to +127 0
the printer
Cassette 3 Leading edge margin for upper cassette of -128 to +127 0
PF-70
Cassette 4 Leading edge margin for lower cassette of -128 to +127 0
PF-70
MP Leading edge margin for MP tray -128 to +127 +5
Duplex Leading edge margin for duplex printing -128 to +127 -20
4. Press the ENTER key. "_" will blink.
>>Cassette 2
[394.1] ###
5. Press the or key to move "_" to the digit position at which the value is to be changed and press the or
key to change the preset value.
If the preset value is increased, the margin will be larger. If the preset value is decreased, the margin will be
smaller.
6. Press the ENTER key. The value is set.
To keep the preset value, press the CANCEL key.
To Next Page
Loading...
Need help?
General
