Item Description
Gateway Enter the IPv4 address of the network gateway.
Configuring the IPv6 Settings
Click the [IPv6 Configuration] tab on the network settings page to configure the IPv6 settings.
IPv6
Item Description
IPv6 Select whether to enable or disable IPv6. You cannot disable IPv6 using
COMMAND CENTER if the machine is currently in use in an IPv6
environment. In this case, use the control panel to disable [IPv6] under
network settings.
When disabled, [DHCP], [Manual Configuration Address], [Prefix Length],
and [Gateway Address] below cannot be configured.
IPv6 Address
Item Description
DHCP Select whether or not the machine obtains its IPv6 address from a DHCP
server. To specify the machine's IPv6 address manually, select [Inactive]
and enter the machine's IPv6 address in [Manual Configuration Address].
IP Address (DHCP) Displays the IPv6 address obtained from the DHCP server when [DHCP] is
set to [Active].
Stateless Address Displays up to four stateless auto addresses.
Gateway Address Displays the machine's default gateway address.
Configuring the Network Settings
321
To Next Page
Loading...
