2M8/2M9-2
1-3-2
(2) Maintenance modes item list
Section
Item
No.
Content of maintenance item
Initial
setting
General U000 Outputting an own-status report -
U002 Setting the factory default data -
U004 Setting the machine number -
Operation
panel and
support
equipment
U201 Initializing the touch panel -
U203 Checking DP operation -
U222 Setting the IC card type Other
Mode setting U250 Setting the maintenance cycle 200000
U251 Checking/clearing the maintenance count 0
U252 Setting the destination -
U253 Switching between double and single counts Double count
U260 Selecting the timing for copy counting Eject
U285 Setting service status page On
U332 Setting the size conversion factor 1.0
U345 Setting the value for maintenance due indication 0
Image
processing
U410 Adjusting the halftone automatically -
U411 Adjusting the scanner automatically -
U425 Setting the target -
Fax U600 Initializing all data -
U601 Initializing permanent data -
U603 Setting user data 1 DTMF
U604 Setting user data 2 2 (120 V)
1 (220-240 V)
U605 Clearing data -
U610 Setting system 1
Setting the number of lines to be ignored when receiving a
fax at 100% magnification
Setting the number of lines to be ignored when receiving a
fax in the auto reduction mode
Setting the number of lines to be ignored when receiving a
fax (A4R/LetterR) in the auto reduction mode
3
0
0
To Next Page
Loading...
