KMnet Viewer 5.2 73
Authorization depends on the type of user name and password
available on the printing system.
For some print systems, the correct Login user name and
Password must be set in Communication Settings.
For other print systems, the correct Command Center
administrator password must be set in Communication
Settings.
For multi-function devices, the user must be registered in the
Device User List, with administrator privileges. Alternatively, the
master Login user name and Password must be provided.
Beginning Firmware Upgrade
If there is anything in the settings you want to change, click Back and
return to the page of your choice. If you want to start the wizard over
from the beginning and reenter settings, click Cancel. If you are sure
you want to start the upgrade process, click Upgrade.
Once you click the Upgrade button the upgrade process begins on
the target device.
Note: The Start of Job String must be blank for the logical printer
used for the firmware upgrade.
Warning: If a device is turned off or loses power at a critical point
during the upgrade, the device could become inoperable and require
a service visit to replace damaged components.
Canceling Firmware Upgrade
You have the option to abort the upgrade process between actual
device upgrades. If there are no devices remaining to be upgraded
after the one currently processing, a warning message directs you to
try again later.
Note: Aborting an active upgrade session does not stop upgrades
that are currently processing, for example, downloading firmware to a
device. Therefore, aborting an upgrade may take several minutes
until downloading to the current device or devices is completed.
Saving the Firmware Upgrade Export File
All firmware upgrade information is displayed. The export file
contains the results for each device. If the upgrade for that device
failed, the reason for the failure is noted. The firmware versions
To Next Page
Loading...
