2LK/2LN/2LM/2LC-2
1-4-24
7110 CF paper entry sensor stay
jam
CF paper entry sensor (CFPES) is not turned off
within specified time of its turning on.
K
7200 CF eject sensor non arrival
jam
CF eject sensor (CFES) is not turned on within
specified time since centerfold operation starts.
K
7210 CF eject sensor stay jam During centerfold operation, CF eject sensor
(CFES) is not turned off within specified time of its
turning on.
K
7300 CF eject sensor non arrival
jam
CF eject sensor (CFES) is not turned on within
specified time since three fold operation starts.
K
7310 CF eject sensor stay jam During three fold operation, CF eject sensor
(CFES) is not turned off within specified time of its
turning on.
K
7400 CF side registration sensor 2
non arrival jam
CF side registration sensor 2 (CFSRS2) is not
turned on within specified time after driving the CF
side registration motor 2 (CFSRM2).
K
7500 CF side registration sensor 1
non arrival jam
CF side registration sensor 1 (CFSRS1) is not
turned on within specified time after driving the CF
side registration motor 1 (CFSRM1).
K
7600 CF staple operation error CF staple sensor (CFSTS) is not turned on within
specified time after driving the CF staple motor
(CFSTM).
K
7700 CF paper conveying sensor
non arrival jam
CF paper conveying sensor (CFPCS) is not turned
on even if a specified time has elapsed after the
machine eject signal was received.
K
7710 CF paper conveying sensor
stay jam
CF paper conveying sensor (CFPCS) is not turned
off within specified time of its turning on.
K
7800 MB eject sensor non arrival
jam
MB eject sensor (MBES) is not turned on even if a
specified time has elapsed after the machine eject
signal was received.
K
7810 MB eject sensor stay jam MB eject sensor (MBES) is not turned off within
specified time of its turning on.
K
7950 Paper interval error jam An illegal inter-page or inter-copy interval has
occurred (4000-sheet finisher).
K
7951 An illegal inter-page or inter-copy interval has
occurred (1000-sheet finisher).
K
9000 No original feed DP feed sensor (DPFS) does not turn on within
specified time during the first sheet feeding (Retry
5 times).
H
9001 DP original conveying jam DP timing sensor (DPTS) turns off within the speci-
fied time since the sensor turns on.
H
9002 DP sensor stay jam Sensor in the conveying system is on since original
feeding starts.
H
Code Contents Conditions
Jam
loc
ation*
*: Refer to figure 1-4-1 for paper misfeed indication (see page 1-4-1).
To Next Page
Loading...
