Kyocera TASKalfa 3050ci - Slit Glass;Dual scanning area

2LK/2LN/2LM/2LC
1-5-46
4. Remove four screws (M4 × 10) and
then remove the fuser unit.
5. Check or replace the fuser unit and refit
all the removed parts.
6. When replacing the new fuser unit, pro-
ceed as follows:
1) Performs maintenance mode U167
(clearing the fuser count) (see page
1-3-105).
2)Performs maintenance mode U464
(Calibration) (see page 1-3-175).
3)Performs maintenance mode U469
(Auto color registration correction)
(see page 1-3-182).
4)Performs maintenance mode U410
(Adjusting the halftone automatically)
(see page 1-3-155).
Figure 1-5-74
Screws
(M4×10)
Screws
(M4×10)
Fuser unit