2LK/2LN/2LM/2LC-2
2-3-20
YC7
1 GND - - Ground
Connected to
front PWB
2 WTNR_SET - - Not used
3 INTER_LOCK - - Not used
4 IH_CORE_SENS - - Not used
5 IH_CORE_MOT_
REM
- - Not used
6 IH_CORE_CLK - - Not used
7 WTNR_LED O 0/3.3 V DC (pulse) WTS1 LED emitter signal
8 IH_COIL_FAN_AL
M
I 0/3.3 V DC FUFFM alarm signal
9 IH_COIL_FAN_H O 0/24 V DC FUFFM: On/Off
10 IH_COIL_FAN_L O 0/24 V DC FUFFM: On/Off
11 EXIT_FAN O 0/24 V DC EFFM: On/Off
12 CONTAIN_FAN - - Not used
13 JUNC_SOL_REM O 0/24 V DC FSSOL: On/Off (ACT)
14 JUNC_SOL_RET O 0/24 V DC FSSOL: On/Off (RET)
15 GND - - Ground
16 EXIT_PAPE_SEN
S
I 0/3.3 V DC EFS: On/Off
17 EXIT_FEED_SEN
S
I 0/3.3 V DC SBS: On/Off
18 SB_MOT_REM O 0/3.3 V DC EM: On/Off
19 SB_MOT_PH O 0/3.3 V DC EM control signal
20 SB_MOT_CLK O 0/3.3 V DC (pulse) EM clock signal
21 SB_MOT_PD O 0/3.3 V DC EM control signal
22 SB_MOT_DIR O 0/3.3 V DC EM drive switch signal
23 GND - - Ground
24 DLP_FAN_ Bk_H O 0/24 V DC DEVFM2: On/Off
25 DLP_FAN_ Bk_L O 0/24 V DC DEVFM2: On/Off
26 DLP_FAN_CLR_
H
O 0/24 V DC DEVFM1: On/Off
27 DLP_FAN_CLR_L O 0/24 V DC DEVFM1: On/Off
28 WTNR_SET I Analog WTS2 detection signal
29 WTNR_NEAR I Analog WTS2 detection signal
30 WTNR_VCONT O 0/3.3 V DC WTS2 control signal
31 GND - - Ground
32 ROT_MOT_REM - - Not used
33 ROT_MOT_CLK - - Not used
Connector Pin Signal I/O Voltage Description
To Next Page
Loading...
