4.INSTALLING PRINTER DRIVERS FOR MACINTOSH
Installing the Printer on Mac OS X 10.2.4 to Mac OS X 10.5.x 99
4 INSTALLING PRINTER DRIVERS FOR MACINTOSH
y If you delete a self-signed certificate registered to this equipment while SSL for HTTP network service is
enabled, access to the COMMAND CENTER is refused. In this case, temporarily disable SSL for HTTP
network service on the control panel and then access the COMMAND CENTER. Then enable SSL again.
For HTTP network service, refer to the COMMAND CENTER Guide. For instructions on how to set it on
the control panel, refer to the MFP Management Guide.
y When IPP/SSL is enabled, click [More Printers] while pressing the [option] key. In the displayed dialog box,
select “Advanced” in the drop down menu and specify as followings:
- Device: Internet Printing Protocol using HTTP
- Device Name: <Any Name>
- Device URI: http://<IP address>:443/Print
- Printer Model: HS Series
- PPD: HS Series (or UK)
4
Click [Add].
The [Installable Options] window appears.
5
Set the following options.
y Finisher
Not Installed — Select this if a finisher is not installed.
Multi-Position Stapler — Select this when the Finisher or Saddle Stitch Finisher is installed.
Multi-Position Stapler and Hole Punch — Select this when the Finisher or Saddle Stitch Finisher and Hole Punch
unit are installed.
Even if you select [Not Installed] for the Finisher option during print settings. The finisher options such as
stapling and hole punching can be selected. If you select the finisher options for printing but the finisher is not
installed, finisher settings will be ignored and printing will be performed correctly.
y Drawers
LCF — Select this when the LCF is installed.
LCF is not available for some countries or regions.
To Next Page
Loading...
