15
hitch.
5. Close the coupler latch after completely seated, then insert a pin
with a lock key or a lock.
6. Install weight distributing bars (equalizer), when required, as
recommended by hitch supplier.
7. Retract the tongue jack to its maximum height.
8. Attach the cable for the breakaway switch to the tow vehicle.
9. Attach safety chains as per your state laws.
10. Plug in your 12-volt, seven way electrical connector from the tow
vehicle to the trailer connector.
11. Below are listed numerous items that should be inspected and
tested before traveling:
q All lights working on outside of coach.
q Stabilizer jacks in retracted position.
q Steps in retracted position.
q Refrigerator door latched completely.
q Loose items in secure position.
q Test brakes for operation before entering roadway.
The Safety Chain (Travel Trailer)
Safety chain requirements will vary from state to state. The chain
supplied with your coach meets SAE requirements for maximum
gross trailer weight.
1. Cross the left chain under the coupler and attach to the right
mounting slot in the hitch head of tow vehicle.
2. Now take right chain under the coupler and attach to left
mounting slot in hitch head.
TRAVELING_______________________________________
Weights
For safety reasons and federal regulations, KZRV provides
accurate weight specifications to owners. On the exterior left front
corner of the coach you will find the Federal “Vehicle Identification
Number” sticker, as required by the federal government. This tag
Remember – always have the safety chain attached to tow vehicle, as
required in your state.
CAUTION
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
