91
OPERATING INSTRUCTIONS FOR UNITS WITH DIRECT SPARK
IGNITION GAS VALVE.
1. Full operation and ignition occurs on the external side of this
appliance. By removing out side grill will evacuate any odors or
propane should there be any.
2. Be sure propane supply and 12 volt DC. are available.
3. Turn “ON” the propane supply.
4. Turn on electrical power to the appliance.
5. Turn switch marked “WATER HEATER” which is located on the
monitor panel, to “ON” position. If the burner does not light, the
system will automatically attempt two more tries for ignition
before lock out. NOTE: Each ignition cycle will have a fifteen
second purge before spark cycle if the system is a three try
System.
6. If lock-out occurs before main burner lights, turn switch to “OFF
wait five seconds and turn switch to “ON” position. This will
restart the ignition cycle. The first start-up of the heater may
require several ignition cycles before all air is purged from the
propane lines.
If the burner will not come on, the following items should be checked
before calling a service person.
1. Switch turned off.
2. Propane supply to heater is empty or turned off.
3. Reset button on ECO is tripped.
4. If burner fails to light, call a Suburban Service center or a local
RV Service agency
OPERATING INSTRUCTIONS—ELECTRIC ELEMENTS
Electric water heaters are designed to operate with a minimum
amount of service problems, however, proper operation and care is
essential.
By far the most common trouble with electric water heaters results
from energizing the water heater before it is filled with water. Even
brief operation of the electric element without water in the tank will
burn out the electric heating element.
Before the electric element will operate, the switch located behind
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...