85
combustion. Only qualified technicians with proper equipment
should make any mechanical adjustments.
Voltage must be between 10.5 volts to 13.5 volts at the furnace
during operation. Below 10.5 volts the furnace will shut down. Both
high and low voltage places excessive wear on the motor and
brushes.
Speed of blower is altered by voltage—-low voltage slows blower
down , sail switch fails to open and the result is no heat,
Any mechanical adjustments, such as electrode adjustments, must
be performed by a qualified service technician.
RANGE AND OVEN TOP BURNER OPERATION
The Toy Hauler group use the standard oven with three top
burners. These appliances operate with propane only, NEVER
natural gas or methane.
Stove top burners do not have a standing pilot light and need to be
lit each time they are used. Matches or special hand held lighters
are suggested to be used.
OPERATING INSTRUCTIONS
TOP BURNNERS
1. Know which knob controls which burner. Always be sure all
burners are turned off when the stove is not in use.
2 Verify sufficient propane supply before attempting to light the
burner ports.
3. Depress knob and turn fully counterclockwise to “LITE” position.
a. Air in the propane line will significantly delay burner
ignition. The burner may light unexpectedly as the air in the
lines clears and is replaced with propane. This unexpected
ignition could burn you. Air in the propane lines may occur
after the vehicle propane bottle and/or tank is refilled, during
and after servicing other appliances on the same propane
Be sure all control knobs are turned “OFF” when you are not cooking.
Someone could be burned or a fire could start if a burner is accidentally
left on or unattended even if only momentarily.
WARNING
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...