29
choose to balance the tires on your unit, however this will not be
covered under warranty.
Wheel alignments may be needed periodically due to road hazards,
such as pot holes, etc. This also is not covered under warranty, due
to being a uncontrollable element. Wheel alignments, will assist with
getting the maximum life from your tires. Alignments require special
equipment, and should be performed by a trained technician.
Tire Repair
The proper repair of a punctured tire requires a plug for the hole and
a patch for the area inside the tire that surrounds the puncture hole.
Punctures through the tread can be repaired if they are not too
large, but punctures to the sidewall should not be repaired. Tires
must be removed from the rim to be properly inspected before being
plugged and patched.
Tire Fundamentals
Federal law requires tire manufacturers to place standardized
information on the sidewall of all tires. This information identifies
and describes the fundamental characteristics of the tire and also
provides a tire identification number for safety standard certification
and in case of a recall.
* U.S. DOT Tire Identification Number –This begins with the
letters “DOT” and indicates that the tire meets all federal
Standards. The next two numbers or letters are the plant code
where it was manufactured, and the last four numbers represent
the week and year the tire was built. For example, the
numbers3197 means the 31st week of 1997. The other numbers
are marketing codes used at the manufacture’s discretion. This
information is used to contact consumers if a tire requires a
recall.
* Tire Ply Composition and Material Used– The number of plies
indicates the number of layers of rubber-coated fabric in the tire.
In general, the greater the number of plies, the more weight a
tire can support. Tire manufactures also must indicate the
materials in the tire, which include steel, nylon, polyester and
others.
* Maximum Load Rating-This number indicates the maximum
load in kilograms and pounds that can be carried by the tire.
* Maximum Permissible Inflation Pressure-This number is the
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
