64
When disconnecting propane containers, you must turn the ACME
fitting in a clockwise direction because left-hand threads are utilized.
When reconnecting, turn connections counterclockwise. Connec-
tions must be tight, however DO NOT over-tighten.
INSTALLING PROPANE CONTAINERS
KZ recreational vehicles are equipped with 20 and 30 pound pro-
pane containers, depending on floor plan models
Mounting and attaching instructions are listed below.
1. Thread the long rod into the base plate.
2. Set both bottles into place as shown on page 66.
3. Drop the double hook bracket over the rod and hook onto the
bottle.
4. Attach the wing nut to hold the bracket and tighten to hold the
bottle to the plate.
5. Attach the regulator with the vent down to the bracket.
6. Attach the main hose from the regulator to the manifold fitting in
the frame.
7. Attach two short pigtail hoses to the regulator and bottles at the
ACME fitting
8. Test all propane connections for leakage.
A warning label has been located near the propane container. This
label reads as follows
!
DO NOT use tools to open or close the tank valve. HAND TIGHTEN ONLY to
avoid damage to the valve or handle.
CAUTION
!
Propane cylinders shall not be placed or stored inside the vehicle. Propane
cylinders are equipped with safety devices that relieve excessive pressure
by discharging gas to the atmosphere.
FAILURE TO COMPLY COULD RESULT IN DEATH OR SERIOUS INJURY.
DANGER
!
PDF created with pdfFactory trial version www.pdffactory.com
To Next Page
Loading...
