ESI-2000
Pilot’s Guide 3-11
Operating Instructions
Cautionary Messages
CROSS CHECK ATTITUDE & HDG
PRESS + TO ALIGN, - TO CLEAR
CROSS CHECK ATTITUDE
PRESS + TO ALIGN, - TO CLEAR
The cautionary messages functionality is only used by release 1.2. The
messages are displayed when a overrate condition is detected from
the ESI-2000 rate sensors and gives the pilot the option to perform or
not perform an alignment.
The cautionary message is displayed on the lower portion of the
screen above the heading readout and slip/skid indicator.
If the ESI-2000 is congured for a magnetometer as the heading
reference, then the following message is displayed if an overrate
condition is detected and magnetic heading data is valid.
If the ESI-2000 is congured for a magnetometer as the heading
reference, then the following message is displayed if an overrate
condition is detected and magnetic heading data is invalid.
CROSS CHECK ATTITUDE
PRESS + TO ALIGN, - TO CLEAR
If the ESI-2000 is congured for either no heading or for external
digital heading, then the following message is displayed if an overrate
condition is detected.
ERRORS AND INVALIDITIES (Continued)
To Next Page
