TM00358 Rev. A Chapter 2 - Operator Gimbal Menu
L-3 WESCAM October 2007
All Rights Reserved 41
ZOOM MULTIPLIER ON, OFF Enables or disables attenuation of steering sensitivity relative to the focal
length of the Video in Control. At wide focal lengths, less steering input is
needed for turret movement, while narrow focal lengths need greater input for
steering movement.
ZOOM MULT. AZ. GAIN 0 to 100 Alters the sensitivity of azimuth (horizontal) steering to slow camera panning
as the degree of zoom increases.
ZOOM MULT. EL. GAIN 0 to 100 Alters the sensitivity of elevation (vertical) steering to slow camera tilting as
the degree of zoom increases.
AZIMUTH GAIN 0 to 100 Sets the responsiveness of horizontal steering movement.
ELEVATION GAIN 0 to 100 Sets the responsiveness of vertical steering movement.
AZIMUTH FWD -179° to +180° Sets the horizontal angle when the turret is in the Forward position. Customer
unique forward position is set to -90°.
ELEVATION FWD ±90° Sets the vertical angle when the turret is in the Forward position.
STEERING FLTR 0 to 100 Increases or decreases the responsiveness of steering controls. 75 is the
recommended setting.
Note: A value of 100 will disable steering.
AUTOSCAN ON, OFF Initiates an Autoscan steering mode using the configured steering position,
sweep margins and sweep rate parameters.
AUTOSCAN AZIMUTH
CENTER
-179° to +180° Configures the horizontal angle for a sector scan.
AUTOSCAN ELEVATION
CENTER
± 45° Configures the vertical angle for a sector scan.
AUTOSCAN WIDTH 1° to 90° Configures the sweep width of a sector scan.
AUTOSCAN RATE 0.1° to 10.0° Configures the sweep rate for a sector scan.
ACTION FIELDS
AUTO NULL – Resets the zero pressure steering reading and removes steering drift when
steering is stopped.
Note: When executing Auto Null, make sure you have no input pressure
applied to the steering controls.
FACTORY DFLT – Resets all user configured value fields to factory default settings.
DONE – Exits menu.
Table 2-11 Status Information and Controls in the Level 2 Operator Gimbal Menu (Continued)
Field Values Description
To Next Page
Loading...