Labcyte Echo 550 - Uninstall the Echo Software; Upgrade the Echo Software

Installation and Relocation 2-9
2.3.2 Uninstall the Echo software
If you need to uninstall the Echo software, use the following procedure:
1. Click the START button on the Windows Taskbar.
2. Point to SETTINGS and select CONTROL PANEL.
3. Double-click ADD OR REMOVE PROGRAMS.
4. Select Echo liquid handler and click REMOVE.
2.3.3 Upgrade the Echo software
Upgrading the software requires a new Echo software CD. Contact Labcyte
Service and Support for the most current version. See “Contact
information” on page 7-1.
Depending on your current software version, you may need to run a clean
installation. Check with Labcyte Service and Support to determine if your
software can be upgraded. If not, you will need to perform a new (or clean)
installation. Back up your existing liquid transfer and plate definition data.
1. Insert the new Echo liquid handler software CD on the client PC.
2. Follow the installation instructions. See “Install the software” on
page 2-7.