44 Operating the AUTOMIZER
TM
RECYCLER
Visual Inspection
Before starting the vehicle, the operator MUST perform a visual inspection of the truck. Ensure the
engine is not running and the parking brake is set.
Ensure the cleanliness of lamps, safety labels, camera lenses, mirrors, windows, and the vehicle in
general.
Ensure that safety equipment is present (i.e. fire extinguisher, first aid kit).
Ensure there is no structural damage.
Ensure that there is no unusual wear, distortion, cracking, leaning, leaking on the vehicle.
Ensure that hydraulic oil level (sight gauge on tank) is as recommended (cylinders must be
collapsed).
Ensure that the hydraulic cylinders do not leak, and ensure mounting pins are secure.
Ensure the hydraulic tank shut off valve is fully open.
Ensure there is no mechanical problem: structure, rollers, hinges, door locks, wear items, etc.
Report any defective system to maintenance personnel.
Ensure there are no leaks, cracks or other types of problems on the frame area, fuel tank, hydraulic
tank, air tanks (air tanks must be drained every day), cleaning trap and wheels.
Ensure the tailgate is fully closed, BOTH tailgate safety pins are in place and rollers are on main
locking pins.
Once the visual inspection is over, you must start the engine to check if the systems are working
properly.
Starting the Vehicle
To start the AUTOMIZER
TM
RECYCLER:
1. Before starting the engine, check the following items:
1 a. Transmission shifter is on neutral.
1 b. Parking brake is on (see Cab Console on page 31).
1 c. Hydraulic system is off (see Cab Console on page 31).
2. Start the vehicle as stated in the chassis manufacturer manual.
3. Switch ON the pump (switch on the control console) to engage the hydraulic system (the air
pressure has to be at a minimum of 70 psi). See Cab Console on page 31
4. Turn on all light switches.
5. If required, move the truck to an appropriate area to perform the daily inspection.
6. Report any defective system to the maintenance personnel.
Body Inspection Procedure
Exit the cab to continue your inspection. Bring a rag along to clean all accessible lights, stickers,
camera lens, etc. Check for mechanical problems: rollers, hinges, door lock mechanisms, wear items,
etc. Report any defective system to the maintenance personnel.