EasyManuals Logo

Labrie automizer Operator's Manual

Labrie automizer
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #59 background imageLoading...
Page #59 background image
54 Operating the AUTOMIZER
TM
RECYCLER
6. Clean all accumulated dirt under cylinder brackets and inside the side tracks using the hoe and
pressurized water if necessary. Be careful with proximity switches to prevent misalignment.
7. Perform a visual inspection for leaks or wear in this area.
8. Rake small pieces of recyclable materials out of the clean-out doors using the hoe.
Figure 4-7
Clean-out door and hoe
9. Finish cleaning the area with pressurized water.
Chassis Daily Cleaning
Chassis daily cleaning procedure:
1. Start the engine.
2. Raise the body until the safety prop is free to tilt under the body.
3. Release the safety prop using the prop handle.
4. Apply the lockout/tagout procedure (see Locking Out and Taging Out the Vehicle on page 27).
5. Clean with pressurized water between the body and the frame.
6. Clean the rear of cab.
7. Perform a visual inspection for leaks or wear in this area.
8. When finished, start the engine, lift the body and bring the safety prop back to its vertical
position, then lower the body.
9. Clean the body all around with water and soap.
10. Rinse.
Clean-out door
Hoe

Table of Contents

Other manuals for Labrie automizer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie automizer and is the answer not in the manual?

Labrie automizer Specifications

General IconGeneral
BrandLabrie
Modelautomizer
CategoryAutomobile
LanguageEnglish

Related product manuals