Operating the AUTOMIZER
TM
RECYCLER 51
Standard Unloading Procedure
Once you have finished your route, make sure the hopper bucket is fully raised, the swivel arm is
folded and locked alongside the body, and the crusher panels are lowered. Keep some recycling
materials not packed in front of the packer in order to help during the unloading procedure.
The following is the standard unloading procedure:
1. Drive the vehicle to the landfill.
2. Ensure the vehicle is on a safe, stable and level ground.
3. Check the overhead clearance before opening the tailgate and raising the body.
4. Remove tailgate safety pins.
Figure 4-5
Safety pin
5. Fully open the tailgate.
6. Raise the body. The recyclable materials should slide out.
7. Slowly move the vehicle forward to prevent the garbage from piling up under the tailgate. This is
the only time you can move the truck with body raised. Do it very cautiously and cover the
shortest distance possible. Always be aware of the overhead clearance.
8. Cycle the packer to help eject the recyclables. It may be helpful to have some recyclables left in
the hopper to enhance the effect of the packer cycle on the recyclable materials.
9. Lower the body and close the tailgate.
10. Put safety pins back in place.
11. Drive away fron the unloading site.
Warning!
Ensure the overhead is clear before opening the tailgate and raising the body.
Safety pin