EasyManuals Logo

Labrie automizer Operator's Manual

Labrie automizer
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
52 Operating the AUTOMIZER
TM
RECYCLER
12. Perform the end-of-the-day inspection. .
Unloading Corrective Actions
As you are unloading the body, some recycling materials may fall or be blown away between the
chassis and the body.
Apply the following procedure for the remaining recyclables stuck on or between the chassis and the
body
:
1. Lift the body until the safety prop is clear to tilt under the body.
2. Release the safety prop by pulling the handle.
3. Pull down the safety prop towards the body.
Figure 4-6
Body safety prop
4. Slowly lower the body so it rests on the prop.
5. Proceed with the necessary cleaning of the chassis.
Warning!
Never move the truck backwards with the body in raised position.
Never raise the body if the tailgate is not fully open.
Danger!
Always use the tailgate safety prop while working under a raised tailgate. The safety prop
should be used even if the tailgate is in fully raised position.
Body safety prop
Safety prop handle
Body hoist

Table of Contents

Other manuals for Labrie automizer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie automizer and is the answer not in the manual?

Labrie automizer Specifications

General IconGeneral
BrandLabrie
Modelautomizer
CategoryAutomobile
LanguageEnglish

Related product manuals