EasyManuals Logo

Labrie automizer Operator's Manual

Labrie automizer
74 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
Operating the AUTOMIZER
TM
RECYCLER 45
Body inspection procedure:
1. Activate the packer for a full cycle.
2. Check the hopper bucket operation.
3. Check if the tailgate safety pins are in place. Put them in place to lock the tailgate properly.
4. As you walk along the side of the truck, clean all safety labels.
5. Check the frame area, fuel tank and air tanks (air tanks must be drained every day), cleaning traps
and wheels for leaks, cracks or other type of problems.
6. At the front end, check lights, mirrors and pump.
7. Go around and check lights, clean camera, labels , lights, etc.
8. Check for hydraulic leaks.
Hopper Bucket Inspection Procedure
On a daily basis, perform a visual inspection of the hopper bucket, looking for leaks, cracks or
premature wear of the moving parts. Refer to the Lubrication section in the Maintenance Manual for
detailed greasing points.
Figure 4-1
Hopper bucket
Danger!
Do not stand directly in the path of the hopper bucket while performaing the inspection.
Warning!
Apply the lockout/tagout procedure at all times. See Locking Out and Taging Out the
Vehicle on page 27
Hopper bucket

Table of Contents

Other manuals for Labrie automizer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Labrie automizer and is the answer not in the manual?

Labrie automizer Specifications

General IconGeneral
BrandLabrie
Modelautomizer
CategoryAutomobile
LanguageEnglish

Related product manuals