46 Operating the AUTOMIZER
TM
RECYCLER
Apply the following inspection procedure:
1. Make sure to park the vehicle on a safe and level ground.
2. Ensure that the parking brake is applied and the vehicle is tagged out for maintenance purposes
(See Locking Out and Taging Out the Vehicle on page 27).
3. With the bucket in its home position, check the following parts for leaks:
3 a. both bucket cylinders;
3 b. hoses and connections;
3 c. both holding valves;
4. Check for loose nuts and bolt locks.
Figure 4-2
Parts to be checked under the bucket
5. Check proximity switches (refer to Maintenance Manual).
6. Start the engine and engage the hydraulic pump (PTO ON).
7. Unfold the swivel arm.
8. Fully lower the hopper bucket.
9. Check the bucket torque tube scraper and both crusher panels.
Bucket cylinders
Holding valves
Bolt lock