LaCie 12big Rack Storage Server
User Manual page 53
BIOS Settings
6.9. Console Redirection (VT100
Mode)
The VT100 operating mode allows remote setup of the board. This
configuration requires a remote terminal that must be connected to
the board through a serial communication link.
6.9.1. Requirements
The terminal should emulate a VT100 or an ANSI terminal. Terminal
emulation programs such as Telix©, HyperTherminal (Windows),
minicom (Linux) or ProComm© (Windows) can also be used.
6.9.2. ANSI and VT100 Keystroke Mapping
Table 61 - ANSI and VT100 Keystroke Mapping
Up <ESC>[A
Down <ESC>[B
Right <ESC>[C
Left <ESC>[D
Home <ESC>[H
End <ESC>[K
F1 <ESC>OP
F2 <ESC>OQ
F3 <ESC>OR
F4 <ESC>OT
6.9.3. VT-UTF8 Keystroke Mapping
The following “escape sequences” are defined in the “Conventions
for Keys Not in VT100 Terminal Definition and ASCII Character Set”
section of “Standardizing Out-of-Band Management Console Out-
put and Terminal Emulation (VT-UTF8 and VT100+)”, available for
download at www.microsoft.com.
Table 62 - VT-UTF8 Keystroke Mapping
F1 Key <ESC>1
F2 Key <ESC>2
F3 Key <ESC>3
F4 Key <ESC>4
F5 Key <ESC>5
F6 Key <ESC>6
F7 Key <ESC>7
F8 Key <ESC>8
F9 Key <ESC>9
F10 Key <ESC>0
F11 Key <ESC>!
F12 Key <ESC>@
Alt Modifier <ESC>^A
Control Modifier <ESC>^C
Home Key <ESC>h
End Key <ESC>k
Insert Key <ESC>+
Delete Key <ESC>-
Page Up Key <ESC>?
Page Down Key <ESC>/
These “escape sequences” are supported by VT-UTF8 compliant
terminal connections, such as Windows Server 2008 Emergency
Management Services (EMS).
AMIBIOS8 Serial Redirection supports these key sequences under
two configurations:
✦ ”Terminal Type” setup question is set to “VT-UTF8”.
✦ ”Terminal Type” setup question is set to “VT100” or “ANSI”
and “VTUTF8 Combo Key Support” setup question is set to
“Enabled”.
To Next Page
