LaCie 12big Rack Storage Server
User Manual page 7
Safety Guidelines
1.1. Safe Handling
CAUTION: If this equipment is used in a manner not specified by
the manufacturer, the protection provided by the equipment may be
impaired.
All plug-in modules and blanking plates are part of the fire enclosure
and must only be removed when they can be immediately replaced.
The system must not be run without all units in place. In order to
comply with applicable safety, emission and thermal requirements
no covers should be removed and all bays must be fitted with plug-
in modules.
Permanently unplug the unit if you think that it has become dam-
aged in any way.
Unplug the unit before moving it.
CAUTION: A fully assembled 12big Rack Storage Server can weigh
up to 32kg (71lb) or 18kg (40lb) without drives installed. Do not try
to lift it by yourself.
Table 01 - Lifting Warning Label
IMPORTANT INFO: The removal of the enclosure top cover or the
power supply mounting cage must only be performed by a service
person. Potential hazards include rotating fans and hot surfaces.
The enclosure top cover must be secured when the enclosure is in
normal use by rotating the lock 90° to the “locked” position (this is
to prevent users/operators from accessing service areas).
1.2. Safety
The 12big Rack Storage Server must only be operated from a power
supply input voltage range of 100 to 240 VAC, 50 to 60 Hz.
Make sure that the socket outlets are located near the equipment
and are easily accessible.
This equipment is intended to operate with two working Power Sup-
ply Units (PSUs) housed in a power supply mounting cage. Before
removal/replacement of a PSU, disconnect all supply power for
complete isolation.
Fig. 01 - Power Supply Mounting Cage Warning Label
A faulty PSU must be replaced with a fully operational PSU within 24
hours. Refer to section 11.3. Environment.
A safe electrical earth connection must be provided to the power
cord. Check the grounding of the enclosure before applying power.
1. Safety Guidelines
To Next Page
