LT-3100 User & Installation Manual Rev. 1.06 Web server
Lars Thrane A/S www.thrane.eu Page 127 of 155
BAM
The LT-3100 system supports BAM via the LT-3110 Control Unit AUX (RS-422) The AUX connector is
described in detail in Auxiliary (AUX) on page 31. BAM must be enabled via the web server, under
Configuration – GNSS and BAM. The baud rate can be configured to 4.800, 9.600, or 38.400 baud. For BAM
configuration see Figure 167 below.
NOTE: The LT-3110 Control Unit AUX connector is providing one bi-directional RS-422 interface.
The Supported BAM sentences are described in BAM sentences on page 98.
To Next Page
Loading...
