BOAT FEATURES AND OPTIONS
SECTION
9
© 2003-2018 Ken Cook Co.
9 - 16
l Bass
HORN SWITCH
The horn switch controls power ON/OFF to sound the horn.
BOARDING AND COURTESY LIGHT SWITCHES
The boarding and courtesy switches control power ON/OFF to boarding lights and
cockpit courtesy lights.
POWER TRIM / TILT SWITCH
The power trim/tilt switch controls power ON/OFF
to the engine’s power trim/tilt electric hydraulic
pump. This switch is usually a three-position switch,
with OFF in the center. If engine is equipped with
power trim and tilt, this system allows you to raise
and lower the lower drive unit and propeller to
adjust trim (the planing, and running angle of the
boat while underway).
The tilt feature positions the lower drive unit up
beyond the power trim range and is used for
trailering, launching or beaching. Never use power
tilt when the engine is running.
NAVIGATION LIGHTS SWITCH
The navigation lights switch controls power ON/OFF to the boat’s navigation,
running and anchor lights. This switch is usually a three-position switch, with OFF in
the center. When the switch is in the NAV position, the red and green navigational,
white stern and running lights, and console gauge lights are activated. When the
switch is in the ANC position, only the white stern light is activated.
Never operate the boat between sunset and sunrise using only the stern light. Use
all navigational lights when operating underway between sunset and sunrise.
BILGE PUMP SWITCH
The bilge pump switch controls power ON/OFF to the bilge pump to remove excess
water from the bilge area of the boat. Some models are equipped with an automatic
bilge pump setting. Switching to AUTO when the boat is in operation will allow
water to be automatically pumped out when it reaches a level that activates the
float switch in the bilge area.
UP
DN
TYPICAL
TRIM
SWITCH
KC-0108-A
To Next Page
Loading...