LARSON Bass - Steering System

GENERAL CARE AND MAINTENANCE
SECTION
10
© 2003-2018 Ken Cook Co. 10 - 8 l Bass
To be effective, anodes must be bare metal. If the boat is
dry-docked more than 24 hours, sand the anodes to clean oxidation from the
surface.
• Zinc and aluminum anodes left in fresh water or zinc anodes used in
brackish water will become covered with white oxide which effectively
stops the sacrificial process and exposes the underwater gear to damage.
• Do not paint sacrificial anodes. Bottom paints/sealants on anodes will
block the sacrificial process and expose the underwater gear to damage.
• Depending on local conditions, some anodes can deteriorate very quickly
and must be closely monitored. See the boat dealer for recommendations.
Because of the vital function that anodes
play in the protection of underwater gear,
replace anodes at the recommended level of
decomposition, or annually, with the correct
type. Boats stored in salt water will normally
need to have the anodes replaced every 6
months to one year. Anodes requiring
replacement more frequently may indicate a
stray current problem within the boat or at
the slip or marina.
Anodes that do not need to be replaced after
one year may not be providing the proper
protection. Loose or low-quality anodes
could be the problem. There could also be a
problem in the bonding system or the wrong
anode material is being used.
The boater/customer has the responsibility in maintaining and ensuring that the
proper anodes are installed for the area (water) in which the boat will be used. See
the boat dealer about changing material or adding additional anodes.
STEERING SYSTEM
Inspect and maintain the boat’s steering system regularly. Frequently check the
hardware at the helm, engine or rudder end for tightness. See the Engine Operator’s
Manual or the steering manufacturer’s information for the appropriate torques.
KC-6006