LARSON Bass - Page 180

WINTERIZATION AND STORAGE
SECTION
11
© 2003-2018 Ken Cook Co. 11 - 4 l Bass
• Perform any annual maintenance not performed during winterization. See
the Engine Operator’s Manual and all equipment manufacturer’s
information for periodic and annual maintenance procedures.
• Check the engine’s cooling water intake areas and screens for
obstructions.
• Check and lubricate the steering system.
• Check all navigational lights.
• Check all controls, gauges, boat systems, accessories and related
equipment for proper operation.
• Check all fire extinguishers for charge level.
• Inspect all safety equipment for condition and operation as applicable.
• When possible, briefly start and run the engine(s) using proper water
supply equipment to check that the engine does start and there are no
major operational problems.
If fogging oil was used during winterization, the engine will
emit excessive white smoke upon initial start-up. This condition is normal and will
diminish once the fogging oil has been cleared through the engine.
• Once the boat is in the water, start the engine.
• Start the engine(s) and watch the gauge readings closely, checking for
leaks and abnormal noises.
• Keep speeds low for the first 15 minutes until the engine has reached
normal operating temperature.
• See the Engine Operator’s Manual and all equipment manufacturer’s
information for additional recommendations.