System Commands
|
|
DISPLAY
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
Response Format
EXAMPLE (GPIB)
DISPLAY, DISP
Command/Query
The DISPLAY command controls the display screen of the oscillo-
scope. When the user is remotely controlling the oscilloscope and
does not need to use the display, it may be useful to switch off the
display via the DISPLAY OFF command. This improves instru-
ment response time since the waveform graphic generation
procedure is suppressed.
The response to the DISPLAY? query indicates the display state of
the oscilloscope.
Note: When the display has been set to OFF, the real time clock
and the message field are updated. However, the waveforms and
associated texts remain unchanged.
DiSPlay <state>
<state> := {ON, OFF}
DISPlay?
DISPlay <state>
The following instruction turns off the display generation.
CMD$=’DISP OFF": CALL IBWRT(SCOPE%,CMD$)
|
|
|
|
|
l
|
i
|
|
|
|
|
|
78
|
|
To Next Page
Loading...
