System Commands
|
II
STATUS
DESCRIPTION
COMMAND SYNTAX
QUERY SYNTAX
Response format
EXAMPLE (GPIB)
RELATED COMMANDS
*ESE
Command/Query
The *ESE command sets the standard Event Status Enable regis-
ter (ESE). This command allows one or more events in the ESR
register to be reflected in the ESB summary message bit (bit 5)
the STB register. For an overview of the ESB defined events refer
to the ESR table (Table 5, page 82).
The *ESE? query reads the contents of the ESE register.
Note: This command can be executed in both local and remote
modes.
*ESE <value>
<value> := 0 to 255
*ESE?
*ESE <value>
The following command allows the ESB bit to be set if a user re-
quest (URQ bit 6, i.e. decimal 64) and/or a device dependent
error (DDE bit 3, i.e. decimal 8) occurs. Summing these values
yields the ESE register mask 64+8=72.
CMD$="*ESE 72": CALL IBWRT(SCOPE%,CMD$)
*ESR?
n
|
I
|
|
i
|
|
l
l
|
i
|
i
8O
|
|
To Next Page
Loading...
